![]() Make sure you configure the serial port just like on the mbed and then you can just read and send data back and forth. On LabVIEW, the serial palette is found in the block panel under: Instruments I/O -> Serial. This will setup a serial communication port on the USB (view the serial example in the mbed handbook found here: ). On the LPC1768, use serial communication and make sure to select the USBTX and USBRX pins. You may need to get familiar with serial communication to send and receive data (or commands) properly.ฤก) Using Serial communication on your mbed LPC1768 and LabVIEW. There are two ways that I see this can be done without too much effort. I know this may be a little late but I thought perhaps more people may need this information.
0 Comments
Leave a Reply. |